PCAN-Term
Plug-in 120-ohm termination for the ends of a CAN or CAN FD bus
Each end of a High-speed CAN bus (ISO 11898-2) needs a termination resistor. If no node sits at an end, or the node there has no termination of its own, PCAN-Term closes the bus with a 120-ohm resistor between CAN_L and CAN_H.
It has a D-Sub socket on one side and a D-Sub connector on the other, so it can sit inline at a device or at the end of a cable. It comes in two housings: PCAN-Term in a plastic case and the smaller PCAN-MiniTerm in a molded body. Both work on CAN FD buses.
Highlights
- 120-ohm resistor between CAN_L and CAN_H
- 9-pin D-Sub socket to 9-pin D-Sub connector (CiA 106)
- Plastic case (PCAN-Term) or molded body (PCAN-MiniTerm)
- Usable on CAN FD buses
Versions and order numbers
- IPEK-003002: PCAN-Term, plastic case
- IPEK-003002-Mini: PCAN-MiniTerm, molded body, all pins connected 1 to 1
Key Specifications
| Spec | Value |
|---|---|
| Order numbers | IPEK-003002, IPEK-003002-Mini |
| Connectors | 9-pin D-Sub socket to 9-pin D-Sub connector (CiA 106) |
| Termination | 120 ohm between CAN_L and CAN_H |
| Housing | PCAN-Term: plastic case. PCAN-MiniTerm: molded body |
| CAN FD | Suitable |
In the Box
- PCAN-Term or PCAN-MiniTerm, in the version ordered
Use it with PCAN-Cable 1 and the PCAN-T-Adapter to put together a bus with tap points. For loose wire ends, see the PCAN-Adapter D-Sub to Screw Terminals.
For quantities, lead time or a quote, contact Pertech.
