PCAN-Adapter D-Sub to Screw Terminals
Connect bare CAN wires to a standard D-Sub socket
Wiring harnesses and test benches often end in loose CAN wires instead of a connector. This adapter takes those wires on a 3-pin screw terminal block and puts them on a 9-pin D-Sub socket, so you can make up custom connections quickly. The socket follows CiA 106, so the adapter is not limited to PEAK products.
If the bus needs termination at that point, you can fit your own resistor, SMD or wired, on the solder pads provided on the board.
Highlights
- 3-pin Phoenix screw terminal to 9-pin D-Sub socket
- D-Sub wired to CiA 106
- For open cable ends
- Solder pads for an optional SMD or wired termination resistor
Key Specifications
| Spec | Value |
|---|---|
| Order number | IPEK-003025 |
| Connectors | 3-pin screw terminal (Phoenix) to 9-pin D-Sub socket (CiA 106) |
| Use | Connecting open CAN cable ends |
| Termination | Not fitted. Solder pads for an SMD or wired resistor |
In the Box
- PCAN-Adapter D-Sub to Screw Terminals
An alternative from Ixxat is the Ixxat CAN Adapter Screw Terminals to D-Sub 9. For PEAK DIN rail devices, use the PCAN-Adapter D-Sub for DR Products. To terminate a D-Sub bus without soldering, use the PCAN-Term.
For quantities, lead time or a quote, contact Pertech.
