PCAN-Cable 1 & 2
Shielded D-Sub cables for building CAN and CAN FD buses
PCAN-Cable 1 and PCAN-Cable 2 are made for wiring a CAN bus. Both are 2 m long and have a 9-pin D-Sub socket at each end, with the shield tied to ground.
PCAN-Cable 2 has 120-ohm termination resistors built in. That makes it the quick choice for linking two High-speed CAN nodes with nothing else on the bus. PCAN-Cable 1 has no termination. Use it for a longer bus that has tap points and separate terminators, such as the PCAN-T-Adapter and PCAN-Term. Both cables also work on CAN FD buses.
Highlights
- 9-pin D-Sub socket at both ends, wired to CiA 106
- 2.0 m length, shield connected to GND
- Cable 1 without termination, Cable 2 with 120-ohm termination
- Usable on CAN FD buses
Versions and order numbers
- IPEK-003000: PCAN-Cable 1, no termination resistors
- IPEK-003001: PCAN-Cable 2, with 120-ohm termination resistors
Key Specifications
| Spec | Value |
|---|---|
| Order numbers | IPEK-003000, IPEK-003001 |
| Connectors | 9-pin D-Sub socket at both ends (CiA 106) |
| Length | 2.0 m |
| Shield | Connected to GND |
| Termination | Cable 1: none. Cable 2: 120-ohm resistors |
| CAN FD | Suitable |
In the Box
- PCAN-Cable 1 or PCAN-Cable 2, in the version ordered
To build out a bus, add the PCAN-T-Adapter for tap points and the PCAN-Term at the ends. The cables connect to PEAK interfaces such as the PCAN-USB FD. For measuring gear, see PCAN-Cable 3.
For quantities, lead time or a quote, contact Pertech.
