PCAN-MicroMod FD ECU Adapter
Screw terminal wiring for the PCAN-MicroMod FD ECU on the bench
The PCAN-MicroMod FD ECU Adapter makes it easy to wire the PCAN-MicroMod FD ECU while you develop and validate a configuration. A color-coded cable set connects the ECU automotive connectors (Molex MX150) to the board, which brings every signal group out on Phoenix screw terminals and the CAN bus on a 9-pin D-Sub socket.
LEDs show the state of the digital I/Os, the supply and the 5 V output. Jumpers can disconnect the LEDs to save current and can tie each analog input ground to the module ground.
Highlights
- Molex MX150 to Phoenix screw terminals
- Color-coded cable set to the ECU included
- CAN on a 9-pin D-Sub socket (CiA 106)
- Switchable 120 ohm CAN termination
- Status LEDs, detachable by jumper
Screw terminal groups
- Power supply and wake-up
- Supply for the high-side switches
- Analog I/Os
- Digital I/Os
- Frequency outputs (low-side)
- 5 V output for sensor supply
Key Specifications
| Spec | Value |
|---|---|
| Order number | IPEH-003086 |
| For | PCAN-MicroMod FD ECU |
| ECU side | Molex MX150 automotive connectors, via cable set |
| Board side | Phoenix screw terminal strips |
| CAN | 9-pin D-Sub socket (CiA 106), switchable 120 ohm termination |
| LEDs | Digital I/Os, power supply, 5 V output |
| Jumpers | LED disconnect, analog ground to AGND |
In the Box
- PCAN-MicroMod FD ECU Adapter
- Pre-configured, color-coded cable set for board and ECU
It is made for the PCAN-MicroMod FD ECU.
For quantities, lead time or a quote, contact Pertech.
