SF100 ISP Evaluation Kit
description
In System Programming (ISP) method Description:
Update your SPI Flash soldered on your application board by using our dedicated programmers: SF100. When connected to the application board, the SF100 programmer can control the SPI bus to read or update the Serial Flash content in a very short time.
ISP-Eval-01 Highlights
- SF100 programmer to update the serial Flash on board x 1
- ISP Evaluation board: To test and validate the ISP method x 1
- 1.27mm 2*4 cable: to connect the ISP evaluation board to the application x 1
- SMT 1.27mm connectors: to solder in place of your application serial Flash x 2
- Resistors: 100 Ohm for safe SPI isolation trials x 10
- Resistors: 47 Ohm for tuned SPI isolation trials x 10
- N MOSFET for SPI and Vcc isolation trials x 10
- Resistors: 0 Ohm for Vcc short cut x 2
- Diodes: for Vcc isolation trials x 2
- Cables with a test clip: to connect the application powers and reset to the ISP evaluation board x 3
