SF100 SPI NOR Flash Programmer
description
DediProg’s SF100 is a high speed “In System Programming” programmer to update the SPI Flash soldered on board or Freescale MCU using Ezport.
The programmer is easily controlled by the computer DediProg Software through the USB bus offering a friendly interface and powerful features to users.
Highlights
- USB Interface
- Start button feature
- Signal conflict protections
- Update Serial Flash soldered on board with application powered or not
- Control Application, controller reset and MOSFET isolation status
- Update the internal Flash of Freescale MCU using the Ezport (MCF5223, MCF5221, MCF5213) or the external SPI Flash of Freescale MCU using the SBF interface (MCF5445, MCF5227)
- Capable of handling two serial flash memories (new feature; provided in SF100 with serial number DP001325, firmware 2.0.4, software 2.0.37 and after)
- Multi-Programmers Capability
- Support Windows 2003 and above
- Support both 32 bit or 64 bit OS
- Support 1 CS pin
Files and media
Key Specifications
| Spec | Value |
|---|---|
| Interface | USB, 2×7 ISP header, 1 CS pin |
| Supported Flash | SPI NOR Flash (W25X80, W25Q series, S25FL512, etc.) |
| MCU Support | Freescale MCU internal Flash via Ezport / external via SBF |
| Dual Flash | Capable of handling two serial flash memories simultaneously |
| Programming Speed | 11s (8Mb) – 297s (512Mb) |
| Modes | ISP, Engineering Mode, Production Mode, CLI |
| OS Support | Windows 2003+ (32/64-bit), Linux (GitHub) |
