PCAN-Router DR
Programmable two-channel CAN router on a DIN rail, with 5 kV isolation
PCAN-Router DR has two High-speed CAN channels and, out of the box, forwards all traffic 1:1 in both directions between them. You set the bit rate with a rotary switch on the front. Its DIN rail casing and wide temperature range make it a fit for control cabinets.
CAN 1 is isolated up to 5 kV from the rest of the device, in line with IEC 60601-1, and the other ports are isolated by at least 500 V. Like the aluminium-cased PCAN-Router, it is freely programmable: a development package with GCC and examples is included, and firmware is loaded over CAN.
Highlights
- Two High-speed CAN channels, 5 kbit/s to 1 Mbit/s
- Bit rate set by rotary switch
- CAN 1 isolated up to 5 kV (IEC 60601-1)
- Freely programmable, NXP LPC21 ARM microcontroller
- Switchable termination per channel
- DIN rail, 22.5 mm wide, -40 to 85 C
Software
- Windows development package with GCC ARM Embedded and programming examples
- PEAK-Flash for Windows 11 (x64/ARM64) and 10 (x64)
- Loading firmware over CAN needs a PEAK CAN interface
Key Specifications
| Spec | Value |
|---|---|
| Order number | IPEH-002213 |
| Microcontroller | NXP LPC21 series (16/32-bit ARM), 32 kbyte EEPROM |
| CAN | 2 x High-speed CAN (ISO 11898-2), CAN 2.0 A/B, 5 kbit/s to 1 Mbit/s |
| Transceiver | NXP PCA82C251 |
| Isolation | CAN 1 up to 5 kV; CAN 2 and RS-232 500 V |
| Connections | Phoenix 4-pole screw terminals for CAN, RS-232 and power |
| Supply | 8 to 30 V |
| Operating temperature | -40 to 85 C |
In the Box
- PCAN-Router DR in DIN rail plastic casing
- Mating connectors for both CAN channels, RS-232 and power
- Windows development package with GCC ARM Embedded and examples
- PEAK-Flash for Windows
- Manual (PDF)
The same function in an aluminium casing is the PCAN-Router; for CAN FD, see the PCAN-Router FD. A PCAN-USB loads the firmware.
For quantities, lead time or a quote, contact Pertech.
