PCAN-MiniDiag FD
Pocket checker for CAN and CAN FD buses of unknown setup
PCAN-MiniDiag FD is a small handheld for first checks on a CAN or CAN FD bus. It measures the bit timing to find the nominal bit rate and, for CAN FD, the data bit rate, so you can connect to a vehicle or machine without knowing its configuration.
It also measures termination, bus load and the voltage levels on the CAN lines and connector, and counts CAN, CAN FD and error frames. It stays in listen-only mode all the time, so it never disturbs the bus. Three replaceable AAA batteries power it.
Highlights
- Automatic CAN and CAN FD bit rate detection
- Termination, bus load and voltage level measurement
- Frame counters for CAN, CAN FD and errors
- Permanent listen-only: no effect on the bus
- IP42 casing with membrane keypad
- Runs on AAA batteries
Functions
- System Info: firmware and hardware version, serial number, battery voltage
- D-Sub Voltages: pins 6 and 9, -40 to 43 V
- CAN Min/Max and CAN Voltages: CAN-High and CAN-Low levels, -5 to 8 V
- Termination, Bit Rate, Bus Load and Statistics
Key Specifications
| Spec | Value |
|---|---|
| Order number | IPEH-003070 |
| CAN | High-speed CAN (ISO 11898-2), CAN 2.0 A/B and CAN FD, ISO and Non-ISO |
| Bit rates | CAN 10 kbit/s to 1 Mbit/s; CAN FD data 66.6 kbit/s to 10 Mbit/s |
| Transceiver | Microchip MCP2558FD |
| Display | OLED, 128 x 128 pixels |
| Power | 3 x AAA batteries (1.2 V or 1.5 V) |
| Protection | IP42 |
| Size | 122 x 69 x 44 mm |
| Operating temperature | -10 to 50 C |
In the Box
- PCAN-MiniDiag FD in plastic casing
- AAA batteries
- Manual (PDF) and printed quick start guide
For scope, trace and transmit functions, step up to the PCAN-Diag FD.
For quantities, lead time or a quote, contact Pertech.
