PCAN-AU5790
Connect a High-speed CAN interface to a Single-wire CAN bus
The PCAN-AU5790 converts between High-speed CAN (ISO 11898-2) and Single-wire CAN (SAE J2411). Its typical job is to let a PEAK CAN interface such as the PCAN-USB work on a Single-wire CAN bus.
A slide switch selects the Single-wire mode: Normal at 33.3 kbit/s, High-speed at 83.3 kbit/s, or Wake-up. The converter normally takes 5 V (150 mA) from the High-speed CAN connection; if the interface cannot supply that much, a 12 V supply is added through the Single-wire CAN connector.
Highlights
- High-speed CAN to Single-wire CAN (SAE J2411)
- Modes: Normal 33.3 kbit/s, High-speed 83.3 kbit/s, Wake-up
- Powered from the CAN interface (5 V, 150 mA)
- LEDs for power and wake-up signals
Key Specifications
| Spec | Value |
|---|---|
| Order number | IPEH-002040 |
| Buses | High-speed CAN (ISO 11898-2) to Single-wire CAN (SAE J2411) |
| Single-wire modes | Normal 33.3 kbit/s, High-speed 83.3 kbit/s, Wake-up |
| Supply | 5 V, 150 mA via the High-speed CAN connection; extra 12 V via the Single-wire connector if needed |
| LEDs | Power (red), wake-up (yellow) |
| Operating temperature | 0 to 70 C |
In the Box
- Adapter in plastic casing
- Manual in PDF format
It works with PEAK CAN interfaces such as the PCAN-USB. For Low-speed CAN, see the PCAN-TJA1054.
For quantities, lead time or a quote, contact Pertech.
