NuProgPlus-U16 Universal Gang Programmer and Duplicator
Up to 16 sites for SPI flash, eMMC and UFS
The NuProgPlus-U16 is the larger manual-operation model of DediProg’s NuProgPlus series. It comes with 8 programming sockets and can be extended to 16 sites, so it programs 16 SPI flash devices or duplicates 16 eMMC or UFS parts in parallel.
Like the rest of the series, it is built on a newly designed FPGA kernel and runs on its own: load a project file, then work from the LCD and keypad with no PC on the line. The operator only presses Start, so nobody can pick the wrong image file or part number by mistake. It programs EEPROM, flash, MCU, eMMC and UFS devices, and duplicates eMMC and UFS parts from a master device.
Highlights
- 8 programming sockets, expandable to 16 for SPI flash, UFS and eMMC
- Copy mode and Program mode
- UFS, eMMC, SPI NOR, SPI NAND, parallel NOR and NAND, EEPROM, MCU, CPLD and FPGA
- Built-in SSD for project files, with project download up to 100 MB/s
- Three start modes: Manual, Auto Detection and Handler
- A PC can link several NuProgPlus-U16 units and program on all of them at once
What types of data and memory areas can the NuProgPlus-U16 duplicate?
- The NuProgPlus-U16 can duplicate specific types of data and memory areas for UFS and eMMC devices. For UFS, it duplicates data, LUN configuration, descriptors, attributes, and flags. For eMMC, it handles the boot area, GPP, user area, and ExtCSD. It's important to note that a master device is required as the data source, and RPMB (Replay Protected Memory Block) is not duplicated.
Production Features
- NAND flash skip-bad-block management and partition files (CSV, DEF, MBN)
- Project files lock the image and part number for each run
- Packages including CSP, BGA, QFN, QFP, SOP, TSOP, SSOP, PLCC and DIP
Key Specifications
| Spec | Value |
|---|---|
| Programming sites | 8 sockets, expandable to 16 for SPI flash, UFS and eMMC |
| Operation | Stand-alone with LCD and keypad, or linked to a PC |
| Supported ICs | UFS, eMMC, SPI NOR, SPI NAND, parallel NOR and NAND, EEPROM, MCU, CPLD, FPGA |
| File formats | Binary, Intel Hex, Motorola S19, and MCU-specific formats |
| Storage | 256GB SSD inside, upgradable to 512GB |
| Project download | Up to 100 MB/s |
| Host interface | USB 3.0 |
In the Box
- NuProgPlus-U16 programmer
- USB 3.0 cable
- Power adaptor
- 256GB SSD, installed
Options: socket adaptors for your IC packages, an SSD upgrade to 512GB, and the HPF-NuProgPlus hand press fixture, which opens 8 single or dual sockets at once.
For a smaller setup, see the NuProgPlus-U8.
Datasheet: NuProgPlus-U16 flyer (PDF).
For the software, the user manual or a quote, contact Pertech.
