SF600Plus-G2U ISP Programmer
ISP and stand-alone universal programmer for production lines
The SF600Plus-G2U is a high-speed universal programmer for in-system (on-board) programming and for stand-alone programming. It programs MCU, FPGA, CPLD, SPI NOR and SPI NAND flash, and EEPROM, and it is controlled over USB or its ATE port, so it fits into in-line ICT and FCT test platforms on an EMS production line.
It is fully compatible with DediProg’s SF600Plus-G2 SPI flash programmer and adds a dedicated on-board programming application. It replaced the StarProg-A and the K110, which DediProg moved to end of life on 1 December 2022. DediProg supplies the SF600Plus-G2U only to customers who have ordered the device license, so contact Pertech to set it up.
Highlights
- Protocols including SWD, JTAG, DAP, UART, I2C, CAN and LIN
- Synchronous or asynchronous programming across several programmers and boards
- Programming voltage from 1.2V up to 12V
- Custom scripts for the programming sequence
- Project mode for stand-alone work, with the ATE port for in-line control
- ARM and FPGA architecture with 4GB of embedded memory
Software
- DPISP CLI: for engineers debugging or verifying from the command line
- DPISP GUI, Engineering mode: for programming ICs with finalized scripts
- DPISP GUI, Production mode: for mass production, on-line or stand-alone
- Blank check, erase, program, verify, and option register editing
- Windows 8, 8.1, 10, 11
Key Specifications
| Spec | Value |
|---|---|
| Architecture | ARM and FPGA |
| Embedded memory | 4GB |
| PC connection | USB 2.0 Type-C, Ethernet |
| ATE interface | Start, Pass, Busy and Error control and status lines, 5V TTL |
| Programming | In-system (ISP); off-line mode with SPI socket adaptors only |
| Supported ICs | EEPROM, SPI NOR and NAND flash, MCU, FPGA, CPLD and more |
| VCC1 / VPP | 1.2V to 5V / 5V to 12V |
| Controls | Power, Pass, Busy and Error LEDs; Start button |
| File formats | Binary, Intel Hex, Motorola and more |
| Replaces | StarProg-A and K110 (end of life 1 December 2022) |
In the Box
- SF600Plus-G2U programmer
- USB 2.0 cable, 1m, USB-A to USB-C
- Power adapter with US and EU plugs
- 2×10 to 2×10 cable and 2×4 to 2×4 cable
- DPISP-CB-20-1 cable
- NuProgPlus socket bottom board
- Product card with the user manual QR code
Options: the G2U-ISO-SWD and G2U-ISO-JTAG isolation boards, and a 1.2m USB-A to USB-C cable.
For SPI flash work at the engineering bench, see the SF600Plus-G2.
For the license, the software, the user manual or a quote, contact Pertech.
